【GWのお知らせ】 4月30日は棚卸しのため出荷作業行いません。次回の発送開始日は5月6日(木)となりますので予めご了承ください。
ホーム/Clariant PC-ABS-GF15
  • 商品説明
      • 商品説明

    Clariant PC+ABS-GF15


    3D printer filament

    Clariant 15% Glass Fiber Reinforced PC+ABS (PC+ABS-GF15) is created by adding 15% glass fibers to a Polycarbonate + Acrylonitrile Butadiene Styrene (PC+ABS) polymer blend to provide a strong and tough material with improved resistance to warpage during printing. Clariant additives are added via a Renol® masterbatch to improve the heat stability and resistance to thermo-oxidative degradation and yellowing.
    General properties
    ・ Strong and tough engineering thermoplastic
    ・ High impact strength
    ・ High heat resistance
    ・ Good low temperature ductility
    ・ Glass reinforcement helps minimize warping during printing
    ・ Reduced thermo-oxidative degradation ・ Minimized undesired yellowing due to ultraviolet light
    Optimized benefits
    · Mechanical and technical application parts that require strength and toughness
    · Prototypes
    · Tools, jigs, fixtures
  • ニュースレターのご登録
  • ご登録いただき、ありがとうございました!
    Copyright © 2020 BRULÉ   All Rights Reserved.
  • Copyright © 2020 BRULÉ   All Rights Reserved.
  • Full site version